Fracture Toughness Characteristics of the New Weldable Steels of 180- to 210-Ksi Yield Strengths

Download or read book Fracture Toughness Characteristics of the New Weldable Steels of 180- to 210-Ksi Yield Strengths written by Peter P. Puzak and published by . This book was released on 1969 with total page 36 pages. Available in PDF, EPUB and Kindle. Book excerpt: The yield strength range for steels from 180 to 210 ksi is currently covered by four weldable alloys of the following nominal chemical analysis: 18%Ni-8%Co-3%Mo maraging steel, 12%Ni-5%Cr-3%Mo maraging steel, 9%Ni-4%Co-0.20%C quenched and tempered (Q and T) steel, and 10%Ni-8%Co-2%Cr-1%Mo-0.10%C Q and T steel. Broad ranges of fracture resistance have been reported for these materials based on various fracture tests, and this report presents information for material selection and design guidance by providing an analysis of the interactions between the metallurgical and mechanical parameters that contribute to the fracture resistance of plate products. Definitions of the interaction between the metallurgical and the mechanical aspects are developed with the use of the Dynamic Tear (DT) test and the Ratio Analysis Diagram (RAD). (Author).